Changing flow rates from the display
Napsal: 05.11.2025 12:29How is the flow control during printing in Marlin?
I assume that:
- Flow 0 = flow of the first layer
- Flow = flow of all other layers
So the possibility of percentage change of flow, which will be generated by slicr.
If this is really the case, then I have one more question later.
Thanks
I assume that:
- Flow 0 = flow of the first layer
- Flow = flow of all other layers
So the possibility of percentage change of flow, which will be generated by slicr.
If this is really the case, then I have one more question later.
Thanks